ok my apoc2k is a little messed but anyways. it just goes a little high on pressure but heres my problem..........my rt ule custom only fires once if not none when gassed up. i shoot once then i cant shoot anymore. i checked if the level 10 wasnt resetting but it was. so whast the problem. i have 3 level 10 shims and 5 in my ult. i have the #1 carrier and i tried the 3 and down. i cant figure this out. please help.
-
rt ule custom, boomstick, ult,apoc2k and x board revi, i want:j&j ceramic. -
leaking too
i forgot to say its leaking too. in the bolt, like down the feedneck and from one of the holes on the valve. im soo confused.rt ule custom, boomstick, ult,apoc2k and x board revi, i want:j&j ceramic. -
GearAGD - "[/tom kaye shakes head in disbelief]"
RT Mag / Minimag / Pump Mag / Sydarm / ULT / Qloader / ELCD / RPG / 1989 Sterling / 2x F2 illustrator
Feed Back HereComment
-
You say the level 10 is resetting but leaking. Remove the shims from the level 10. If that doesn't stop the leak, try a tighter carrier. If the tighter carrier causes bolt stick or is stiff when sliding over the bolt stem, then you may have a damaged carrier o-ring.
The lack of firing may be a velocity adjustment problem. Try increasing your velocity setting until the gun fires consistently. If the velocity is too high at the consistent setting, then put a smaller bolt spring on the bolt and reduce the velocity setting to a usable level.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
i used to be able to use the middle spring but it refuses to shott with that one, i have to use the shortsest one.rt ule custom, boomstick, ult,apoc2k and x board revi, i want:j&j ceramic.Comment
-
Guns
Tippman SL-68 II (First gun and still lovin it)
X-Mag XT00160 (Shiny and Blue)
Custom 'AlphaMag' Mag (X-Valve, Chromed Y-grip, Chromed Galatix Z-body, Gloss Black Rogue Rail)Comment
Comment