on/off /valve/ solenoid issue??

[bunker17]

Well not really sure what it is okay i have a non cut&carved xmag and it used to have and emag valve i changed the valve for and x valve this winter, i changed the x on/off for the emag has i alway told i had to yet know im having some serious isuues general description:
1-the gun will click but won't fire in electro(it used to shoot slowly)
2- it won't fire at all in electro

So i really need help fixing this so any help is appreciated

[Lee]

you may need the quad o-ring that is stock in emag valves. it's a different design for lower friction on the top of the on/off pin. you can get them at the agd online store.

[bunker17]

okay i do have my quad o ring think you can post me a pic of the correct setup of the on/off

[bunker17]

sorry for giving an up but i really nee dhelp with this soon

[bunker17]

need some guidance anyone

[jamescell]

Are you batteries fully charged?

[bunker17]

yes my batteries are charged and also it doesn't shoot when on mechaninc new thing that happened to notice is that the on/ off pin doesn't go back up after using the gun making it kind of impossible to take the valve out unless i disarm the whole gun so help with thi want to play tomorrow

[bunker17]

anyone ??

[jamescell]

yes my batteries are charged and also it doesn't shoot when on mechaninc new thing that happened to notice is that the on/ off pin doesn't go back up after using the gun making it kind of impossible to take the valve out unless i disarm the whole gun so help with thi want to play tomorrow

Not even if you pull the trigger in mech mode? Something is really screwed up if your on off pin is out after pulling the trigger in mech mode. Are you sure the sear is in good condition? Perhaps you have some debris blocking it's motion.

[jamescell]

Ohh yeah, are you sure the on off is installed right? If you had an o-ring in there wrong it could block the on off pins travel. Perhaps it is installed correctly but there is some thing in there?

[bunker17]

so can anyone suppply me a pick of a correct emag on/off top see if tis that because this is really starting to crack me i tried eveyrthing said here yet it doesn't seem to solve it

[AnArchist_1944]

sorry to hijack the thread but Iam having the same problem with mine....except I got the noid to work by attaching a pen spring to the "E" clip and the other end to one of the panel grip screws and poof it works awsome but I would like to know what the actual problem is

[bunker17]

still don't know what it is i want to be like when they tell me what it is so later i can go to the field on sunday

[Tunaman]

as the solenoids get older, you may need to lengthen the plunger rod a few thousandths. Check the length to be 3.005" + or - .005". Hope this helps. If you can fix it send it here.

[AnArchist_1944]

when should you replace your noid? and is my spring mod a good idea or should i try to lengthen the plunger? How would I change the plunger length?