I was putting a macroline fitting on my Automag (Classic Valve) yesterday and I could only get the fitting to screw in about half way. I checked the threading both on the fitting and valve and I could not find any problems. I also tried 2 different fittings and neither worked. Is this normal? Will this cause a problem?
-
they never go in all the way, just make sure you use a sealer, and you should be good to go.GearAGD - "[/tom kaye shakes head in disbelief]"
RT Mag / Minimag / Pump Mag / Sydarm / ULT / Qloader / ELCD / RPG / 1989 Sterling / 2x F2 illustrator
Feed Back Here -
SW45 is right, I just use some teflon tape on mine and they work great.Comment
Comment