Fireblade Que.

[Skywalker]

Just my fireblade and I can't wait to install it, but I need to know the best way to get the trigger pin out. That sucker is really in there. Any advice would help. Thanks

Skywalker

[MonsterMag]

Just my fireblade and I can't wait to install it, but I need to know the best way to get the trigger pin out. That sucker is really in there. Any advice would help. Thanks

Skywalker

Mine was in there good to , sent it to tunaman .He pulled it right out.

[webmstrk9]

Mine was in there fairly snug, just get a hammer and a tap. Remember to tap from right to left, the right being viewed from behind.

[CoolHand]

Just my fireblade and I can't wait to install it, but I need to know the best way to get the trigger pin out. That sucker is really in there. Any advice would help. Thanks

Skywalker

Flip the switch to EMode, then turn the frame over, and drive the pin out from the other side.

Give it a good whack or two (be sure the drift doesn't slip or you'll scratch the frame). If it doesn't move after two or three good shots, turn it over and try from the other side. I've seen them driven in from both sides before, so its a toss up as to which way it will come out. Most seem to have been put in from the selector side though, which is why I suggested you start from the other side (gotta come out backwards of how it went in).

Good luck, go slow and be careful.

[sabrefanpc]

yup. hit on the "safety" side. pin has little ridges so it will only come out one way. Dont know if theyre neccessary but i guess your trigger falling of in a game would be a bad thing

[Skywalker]

Aight guys thanks a lot. Pin came out easy, but putting it back in was a different story. For some reason the length of the pull with the fireblade seems longer then with the stock trigger. Oh well, maybe it's just me. Thanks again.

Skywalker

[CoolHand]

You will need to readjust the back travel stop in the selector tumbler to shorten it back up.