Here is my setup
I got 3 shims in my level 10 with the short spring on it (because i bought this used from some guy and he only had the short spring) also i got the ult with 5 shims (because before with like 2 shims when i tried to fire it it shot once or twice then kept locking or not firing at all the trigger wouldnt even come back out all the way, even sometimes with the 5 shims i got problems)
it seems also when i turn the velocity to around 240 it gives me problems again with the ult. i dont know whats going on also when the tank get to around 100psi or less the damn thing doesnt work right at all it locked up and balls were just rolling out of the barrel then for some reason it worked i fire one or two shots then some balls started to roll out of the barrel again.
i went to the table took out the tank to try and see what was wrong but then when i try to put the tank back in the damn thing starts to leak from the asa then from the valve itself (and this is the point where it is just below 1000 psi). i put the velocity up before to around 260/270 becuase under 250 like i said it wouldnt work right. so i didnt understand when there was such a big leak from the asa and the valve. but when the guy put more air into the tank it worked fine.
i need help seriously when this gun works its like heaven when it doesnt its hell. anyone got any suggestions on maybe the shims or the spring or anything?
i honestly looked all around this forum for similar posts and tried whatever i could but maybe there is something i missed
could it be also from my sear assembly? because it from my classic mag. at some point i thought it could be that.
I got 3 shims in my level 10 with the short spring on it (because i bought this used from some guy and he only had the short spring) also i got the ult with 5 shims (because before with like 2 shims when i tried to fire it it shot once or twice then kept locking or not firing at all the trigger wouldnt even come back out all the way, even sometimes with the 5 shims i got problems)
it seems also when i turn the velocity to around 240 it gives me problems again with the ult. i dont know whats going on also when the tank get to around 100psi or less the damn thing doesnt work right at all it locked up and balls were just rolling out of the barrel then for some reason it worked i fire one or two shots then some balls started to roll out of the barrel again.
i went to the table took out the tank to try and see what was wrong but then when i try to put the tank back in the damn thing starts to leak from the asa then from the valve itself (and this is the point where it is just below 1000 psi). i put the velocity up before to around 260/270 becuase under 250 like i said it wouldnt work right. so i didnt understand when there was such a big leak from the asa and the valve. but when the guy put more air into the tank it worked fine.
i need help seriously when this gun works its like heaven when it doesnt its hell. anyone got any suggestions on maybe the shims or the spring or anything?
i honestly looked all around this forum for similar posts and tried whatever i could but maybe there is something i missed
could it be also from my sear assembly? because it from my classic mag. at some point i thought it could be that.
Comment