hey all, i took my emag to one of the local paintball shops around my area. When I got it back from them after installing my fireblade trigger, my selector switch is all limp. how do i go about fixin this. I dont want to take it back to them because they are hacks, so can you hepl me out.
-
-
I would say they lost your spring and detent. The spring holds the detent against the selector pin. There are divits drilled into the pin where it is to stop. Without the spring and detent, there is nothing to stop the pin from rotating.Except for the Automag in front, its usually the man behind the equipment that counts. -
Originally posted by athomas
Sounds right... Don't take mags to a local shop, as you see what happens... Send it to Tuna instead!Comment
-
is it possible to shoot the emag in e-mode withoutthe selector switch?Comment
-
If you take the selector switch out, it will always be in hybrid mode. It will fire in electronic mode at the beginning of the trigger pull and then will allow the returning trigger rod to hit the back of the trigger. This will give the trigger a bit of kick. It will be very fast when you get used to it.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
where can i find the spring and detent at? how much will it run me?Comment
-
I Suggest you get more then one ball detent. Its kinda hard to get the ball and spring into the hole. The ball might pop out and will be very hard to find again.Comment
Comment