Got smaller parts from AGD

[SteelSoul]

Hey I bought a used warp and the 90% elbow is to small. This is what is going on
On the new adaptor is to small it will not fit the Hose connection, see the pics

When you plug the hose in it just falls out.

When I plug in the old broken clear elbow it fits nice and snug on the End cap.
Looking for some ideas here on what to do to fix this.

I was thinking of cutting a groove in the elbow and using on of the o-rings, yall think this will work?

I used a caliper and it is .00005 of a inch smaller
New one is .860
Old one is .865

[yakitori]

ummm......electrical tape. Thats a brain stormer.

It wont be visible if you do it right since the hose end will be covering it.

[SteelSoul]

I tried Teflon tape and it works ok, but the pressure from the ball stack pushs the hose out after a few minutes

Any more ideas???

[yakitori]

put a couple layers of electrical tape and one dab of super glue. Be sure it is only one dab though, and not a big one. that should hold the force of the warp.

[deadeye9]

I seem to recall that there was a difference in size between the
Pro Team warp adapters and the AGD version. Maybe the used
warp was a PTP version. I would get a new hose, and upper and
lower warp adapters (all from AGD). Then eveything should fit.

[SteelSoul]

Yeah I bought a new hose and elbow and orings
If this does not work then I will buy more stuff.
Its funny I see peeps that buy all these guns and stuff, well I am a part whore LOL

[kevdupuis]

There's a short black plastic adapter about an inch long that the warp hose slides into and it slides on to the 90* adapter. It should be in the warp package on the long powerfeed plug, it looks similar to the top part of the hose adapter that sticks out of the top of the warp.