Question about upgrading to xvalve from rt pro

[kalb_69]

Hey i have an RT Pro valve and rail and am most likely getting an xvalve. First of all the xvalve will fit the rt pro rail right? And i read on teh airgun site u have to keep your RT pro on/off assembly to replace the one in the xvalve. If i get ULT there would not be a problem would there, because its a new on/off assem.

Thanks

[Dayspring]

Yes, you swap the on/off assembly from your RT Pro to the Xvalve. (There really isn't much benefit though- you just save 3oz of weight.)

And no, adding the ULT wouldn't be an issue. You just use shims to achieve the correct pin length. (the ULT pin is .770". The RT Pro pin is .765". One ULT shim is .005". One Level 10 shim is .010". )

[kalb_69]

thanks for the reply