classic valve into an emag body?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • gothsqwd
    #1

    classic valve into an emag body?

    I'm putting a ULE warp left body on my e-mag and I got an idea. I'm thinking of using the Sainless steel PF e-mag body to build another mag. Will the classic valve fit the e-mag body? I'm thinking cheapest route possible here since it will just be a fun project.
    Tags: None
    • Chronobreak
      Rec Poster
      • Mar 2003
      • 5055
      #2
      it wil fit..you might need a diff pin length though for the classic, and the classic wont work as an e-mag(eelctro) valve just so you know

        Comment

        • athomas
          Of course it works-its AGD
          • Jan 2002
          • 8039
          #3
          Yes, the stainless powerfeed emag body will fit on all AGD rails. All AGD valves will fit except the original AutomagRT valve. If you put the body on an older standard rail, make sure the pim (threaded hole) doesn't bottom out on the rail. A tiny bit of sanding will fix this if it is a problem. Other than that, you are good to go.
          Except for the Automag in front, its usually the man behind the equipment that counts.

            Comment

            Previous template Next
            Working...