AGDE XMAG breakin problems

[ICOM]

Hey guys, need a little advice.

Problem:MY LX is too hard on paintball. I will chop a ball every pod or so.

Using
-2shims with 1.0carrier and Short Spring At 250-265velocity.
-Scepter Kit
-Flatine 68/4500 at about 850psi
-AGDE Xmag
-Warp


Thoughts: Problems i think is the warp is pushing a extra ball in the barrel or like half way? OR
It might be the short spring is just too hard....and need a medium spring. Also i heard things about the barrel/module for agde guns?

any advice will help me out, thankyou!

-Scott

[Rift]

Take out the shimms put in the biggest carrier that dosent leak and put the red spring on and try it out.

[temilotzin]

If you are getting a ball and a half in the brech you need to replace your ball detent.

[ICOM]

Well i am not sure if i am getting a ball in half in breech, i dont break/chop every single ball. Was just thinking maybe the warp is pushing a ball through too far or something?

[ICOM]

really help me out...

[zackzel]

Is it doing it with your eye turned on? If so try using the middle spring for the level 10.

[Maggot6]

This has nothing to do with your thread, but what is an ADGE gun? I assume you mean AGD / Airgun Deisngs, but you have about 1000 posts so I figured you knew what you were talking about, Possibly agd Electronic?

[Lohman446]

Maggot AGD - Europe...

And I expect you have problems with the detent - might look into a bit stiffer of one - Rogue makes reasonable ones as do others. I know the ULE bodies use Angel detents - I assume that the X-mag does also and it may be easier to get Angel ones. I have heard a lot of things about weak detents before.