I just did a 12V mod on my warp and it works fine until I plug the intellifeed cable into the warp, then it starts spinning constantly. It spings whether the battery on the emag is on or off. I had the problem of it spinning constanly without the intellifeed connected, so I added a 100uF capacitor to the 12V voltage regulator on the output and ground leads and it fixed the constant spinning. Then I plugged in the intellifeed and it goes constantly again. Should I add another capacitor to the 12V voltage regulator on the input and ground? or should I add one to the intellifeed wire? I'm really lost here, I thought I had it fixed until I plugged in the intellifeed and have done alot of searching and can't seem to find out how to fix this one.
-
-
try adjusting the sensitivity resistor. It's normally used to adjust sound sensitivity, but it can help with electronic "noise" as well. Also, try changing your feed jumpers to a shorter spin cycle. -
got if fixed :)
had one of the jumpers on the positive and it only works when its on the negativeComment
Comment