ule body problem

[nipplez]

I got a vertical feed ULE with an xvalve with lvlx on a classic rail. when i shoot it takes it about a second before i can shoot a second time. i hear it make a pffft sound then it clicks before i can shoot again. however when i put on the powerfeed body it shoots fine. anybody know whats going on?

[undescriptive]

make sure the front frame screw and the field strip screw are torqued the same

sometimes the front frame screw can "bend" the body causing bolt stick....

I usually pop in an allen key into the field strip and tighten it up like that

[nipplez]

thanks for the tip. i tried that but that didn't work.
any other advice out there?

[undescriptive]

try cranking the velocity up a bit too might help....

check your air line to make sure you don't have any PTFE or blockages in the lines (causes some big problems)

hope that helps?

[nipplez]

darn, the velocity isn't the problem either. would it be easier to upgrade to a different rail? that way the mounting hole in the front would fit better? because the mounting hole in the classic rail is rectangle and the newer rails are circular?

[dogEmedic]

Check your detent,

mine came screwed in to far and did the same thing.

[nipplez]

thx ill try that when i get back from vegas, hope that works and if it does, ill buy you a drink

[gothsqwd]

yeah there was a big thread about the detents. Just place a very small oring around the detent and screw it in snug, but not overtight.

[nipplez]

thx guys ill try it out when i get back from vegas. you guys are the best!!!