I got inteliframe in yesterday and followed AGD's directions on installing it, with the exception that i put a headphone plug on my revy and have the wire coming out of the top of my grip and plugging directly into it. After installing it I got to thinking, the entire reason for this mod is to by pass the eye sensor, and without the eye sensor you don't need the board. So I decided to remove the board and the sensor and this is how I have it wired now.
1, The positive side of the battery terminal goes to the phono plug.
2, The other side of the phono plug goes to a on/off switch that I added.
3, The other side of the on/off switch goes to the red wire going to the motor (I want to try and find a plug that will fit that so its plug and play).
4, You then have to run a wire from the green wire to the negative side of the battery.
5, The switch in the frame is wired the same as in the instructions.
I like things simple, and I like playing with electronics. I want to hear any suggestions or concerns with this setup.
1, The positive side of the battery terminal goes to the phono plug.
2, The other side of the phono plug goes to a on/off switch that I added.
3, The other side of the on/off switch goes to the red wire going to the motor (I want to try and find a plug that will fit that so its plug and play).
4, You then have to run a wire from the green wire to the negative side of the battery.
5, The switch in the frame is wired the same as in the instructions.
I like things simple, and I like playing with electronics. I want to hear any suggestions or concerns with this setup.
Comment