HELP!! Raptor UNIREG

[Spacemanvic]

OK, so I think my equipment is showing it's age. Went to go get my HPA tank filled (114CU), and I couldnt get it done. Air kept shooting out of a small hole in the side of my Raptor UNIREG (Air America). Think its a bleeder hole of some sort. I removed the threaded cap at the top, removed the stem that looks like it's got alot of washers on it, then removed what looked like a 10MM casing that rests above a piston valve. Can anyone help? What would be making the thing leak? Is it irreperable?

Thanks!

Vic

[AGD202]

check for scratches on the internals.... dirt could have went through and scratched something or jammed something... i dont know internals of a tank reg but i know that those 2 things can happen and if there is any O-Rings... check those

[Spacemanvic]

Thanks!

I replaced the O-rings, and there was some junk in the spring pack, so I cleaned that up and lubed the pack and piston housing. Will go get tank tested tomorrow.

check for scratches on the internals.... dirt could have went through and scratched something or jammed something... i dont know internals of a tank reg but i know that those 2 things can happen and if there is any O-Rings... check those