Do I need a shorter on/off pin?

[zeroack]

I let a friend who's a shop owner and a AGD tech take a look at my new ule mag. It seems that if we loosen the rear screw it works much much better. However it's very loose. Too loose to use reliably. He said I should look into a shorter on/off pin. Is this a option? Can I buy shorter pin's or do I need to look into how to grind mine down?

Set up:
Ule body
Xvalve
Logic Alpha milled Classic rail
Logic vert frame

Tanx

Zero

[gothsqwd]

tighten the rear screw to finger tight, then loosen up the front frame screw. They need to be about equally tight so that it doesn't bow the body. If one or both are too tight, the body will bend slightly and cause the bolt to stick.

[zeroack]

I've always heard of people adjusting the rear one, but not the front. I'll give that a shot. Thanks

Zero

[Zneaky]

Zero, did this ever fix the problem?

Z