ULE Trigger Pull Kit with Classic valve?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Duff_Man
    Registered User
    • Apr 2005
    • 10
    #1

    ULE Trigger Pull Kit with Classic valve?

    Tags: None
    • Stoble
      Registered User
      • Mar 2005
      • 77
      #2
      ult'd classic

      I tried the ULE trigger in my classic a couple days ago and shortstroked alot. So I had to take it out. If the ULE trigger is working fine in your classic mag, then great! I would check the sear to make sure it's in good condition. Even if it is in good condition it will probably wear faster because of the ULT, so you might want to buy a backup anyways. If you do plan on taking the ULT out, yes you will need a new stock on/off. One question though, does your gun have trigger stops? Please get back to me, I'd like to get mine working better. Note: (I had 5 lv.10 shims and 4 ULT shims, so 14 ult shims total).

        Comment

        • Duff_Man
          Registered User
          • Apr 2005
          • 10
          #3

            Comment

            • onedude36
              Registered User
              • Feb 2005
              • 943
              #4
              In a ult, you pop the on/off out, and unscrew the halves and there should be shims between the halves, but arround the pin. Be very careful not to bend the pin! However, if it works fine, dont screw with it. Just dont. I have friends that do this and end up calling me 'Please come fix this' and quite frankly, it gets annoying.
              "Don't stoned i'm shoot" -someoneiforget

                Comment

                • Duff_Man
                  Registered User
                  • Apr 2005
                  • 10
                  #5
                  Last edited by Duff_Man; 04-24-2005, 05:49 PM. Reason: Link didn't work - took it out.

                    Comment

                    • Arkhangel
                      Registered User
                      • May 2004
                      • 22
                      #6
                      The shims Stoble was referring to are internal to the on/off. If you take the valve out of the gun, the on/off is on the bottom of the valve. After removing the on/off, you can unscrew the on/off halves. That's where you'd find the shims -- they're basically very very thing washers. Like he said: be careful not to bend the on/off pin.

                      I've been puzting around with this for my double gun project (can't afford to get two x-valves at the moment). I have 8 ULT shims in. Been messing around trying to get the valve to fire reliably. I think that having a new air tank with a higher output pressure would help some (maybe Centerflag's 4CE with the 1000psi output if I could find one ). From what I've noticed, the less pressure in the tank, the less it works which makes perfect sense if you think about it.

                        Comment

                        • Duff_Man
                          Registered User
                          • Apr 2005
                          • 10
                          #7
                          Thanks for the info Arkhangel. I have since discovered that I DO NOT have the ULE trigger. Mine is just the one piece on/off - learning as I go - sorry. Hope you can get that double gun working though - we'll need to see pictures of that! I'll get the ULE trigger kit when I can afford to buy an x-valve too. :) Thanks again.

                            Comment

                            Previous template Next
                            Working...