somtin wrong wit mag

[empiremag57]

ule set up for left side warp
warfeed
intelframe
classic valve
freak set
68/4500 bulldog tank
empire reloader

every time i try to shoot faster the ser like sticks nd doesnt recharge. most of the time this only happens after ive broke some paint but sometimes it happens even if i didnt break any paint. whats the prob.tell me what u think.

[Lohman446]

Do you have level ten in it?

[gothsqwd]

This would have done better posted in the tech forum, but Try this:

1. back off your front and rear trigger frame screws until they are loose.
2. re-tighten them until they are snug, but not over-tight, and are evenly tightened. if one is much tighter than the other, it can cause the barrel to sflex slightly causing the bolt to bind/stick.

Also, make sure you have completely oiled the marker, with a little extra on the on/off valve.

[empiremag57]

no i dont have level ten whating to get x-valve which comes wit level ten

[AnimalMother]

Why do you need an Empire reloader for a mechanical Mag?

[jackbauer]

no i dont have level ten whating to get x-valve which comes wit level ten

http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=8&categoryID=9

last time i checked the x valve did come with the lvl10

[AnimalMother]

http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=8&categoryID=9

last time i checked the x valve did come with the lvl10

I think that's what he just said.

[goforbroke]

Try replacing your power tube spacer with a larger one but not too large or then air will leak down the barrel.

[jaredborne]

Why do you need an Empire reloader for a mechanical Mag?

Umm some people do shoot faster than their hoppers load... thus, needing a faster loader