No shoot after pulling the trigger

[ADDES]

Hye everybody

I'm quite newbie in AGD tech

I just received a beautiful MAG



But it doesn't shoot!

When I pull trigger, the sear goes "behind" like usual

But no reaction = no shoot!

And after a few seconds, the sear come back "automaticly" in its departure position

Does it mean something to someone?

I clean and grease ON/OFF but nothing changes

[kcam911]

lvl 10?

Did you tune the level X? It may be the problem, when I got my mag It would fire 3 or 4 times then it wouldnt recharge. I tuned the lvl 10 and now it works like a charm.

-Kcam

[D-Block]

Make sure if you're using an on/off ASA it is "on" a good way to let a good airflow in.

[warbeak2099]

You're getting bolt stick. Go to a larger carrier, the next largest one. Don't go too large or you'll start getting a leak. Also, make sure your front frame screw and field strip screw are tightened down the same amount. If one is screwed in too much more than the other, it will cause the bolt to stick.

[GA Devil]

not to make you sound stupid but have you tried turning up the velocity? Ive had a few come in that "wouldnt shoot" with same discription and turnign them up is sometimes the trick. Not sure how they get turned down but it happens.