Wobble on sear

[Alpha]

My sear (on an RT Pro) seems to have wobble in it. Right now I dont have a body in it, but when I did,

the part of the sear thats supposed to push the on/off pin gets caught up on the body. As a result, the trigger would go stiff, and I'd have to degass the marker, take it apart, and reassemble.

I found that the culprit was partly due to the field strip screw and trigger screw not being tighetned enough.

Its still happening, and now it seems worse. The sear can move a few millimeters sideways on its axis.

Remedy?

[alooney11]

The sear should stay in the middle did you alter it in any way? When you have the sear in the rail with no body, or frame, can you move it side to side?

[AGDlover]

maby try a new sear, if its still happening then try a new sear pin if its still happening try a new rail

[Alpha]

I talked to RogueFactor adn it seems I have a bad sear. For anyone else who has the same problems, this is the rundown:

Take your sear out of your rail. Push on the brass bushing that is in the middle of the sear. If it pops out, you have a bad sear. They are supposed to be machine pressed into place and are not supposed to come out.

AGD should replace it fo free.

I'll talk to tuna and see if he can hook me up at AONE7.