Emag pulling a matrix on me!!!

[Emert426]

Ok so I just picked up and IT bodied 3.2 emag with on/off

I charge the batt pack up and slip her in, switch her on and ADG 3.2 pops up.....

All of the sudden it looks like the matrix codes are inside my emag, what I mean by that is where is usually says ADG 3.2 there are now weird symboly flashing instead. So I turn her off, remove the pack, then start over. Same thing.

This time it reads low batt as well.... but I just charged it.

I'm a bit worried.... what should I do?

NOTE! I am sitting by a networking linksys which is wireless.... could this be f'ing with my gun?

[AnArchist_1944]

sounds like your trigger magnet is to far in try sticking your finger behind the trigg a bit then starting it up if it starts normal then back out your trigger magnet a bit or skip step 2 and just back out the trigger magnet a bit and start it up.

[Emert426]

trying that now

[athomas]

Yeah. Sounds like your trigger magnet is too close to the HES sensor. Back off the trigger magnet a bit.

[yakitori]

or your battery pack may need to be replaced. If that doesnt work, talk to AGD about getting a new one.

[Emert426]

backed them out all the way.... still flashed funny.

Should I just send it to tuna and ask him to fix it? I was probably going to get it tuned by him anyways.

[Skywalker]

yeah send it to him, he'll take care of ya.