12 volt Warp question

[MiniSpdRcr]

Does anyone have the schematic how to do this? I have done everything I just cannot find the spot that the capacitor goes on. I have read it goes on the output side, so I put it there and nothing happens. The warp does not function at all. Please help. And I have the 100uF 35v and also a 100uF 50v. Please tell me what to do...its driving me insane.

[luke]

Does anyone have the schematic how to do this? I have done everything I just cannot find the spot that the capacitor goes on. I have read it goes on the output side, so I put it there and nothing happens. The warp does not function at all. Please help. And I have the 100uF 35v and also a 100uF 50v. Please tell me what to do...its driving me insane.

Why are you using a cap? Are you running a Emag?

[MiniSpdRcr]

Whenever I put everything into the warp feed, it just spins without stopping, I read that if you use a 100uF capacitor on it, that it will stop it.

[luke]

Here you go, but I don't think that is your problem.

[alany]

If you haven't already tried it, adjusting the warp sensitivity pot could help the constant spinning problem. If that doesn't fix it, you could solder that capacitor directly across the + and - motor leads. That helps filter out motor "noise" that can trick the warp into spinning continuously.