when i hook up my nitro to my mag it leaks out of the mainbody. does this mean that i could have an o-ring leak? it wasnt leaking yesterday and was firing just fine.
-
-
May want to further specify "main body"... IF you mean out the back, check your reg seat, and turn down your velocity.... And lube the living "heck" out of it... -
sorry... its just leaking out where the barrel is... i guess from the valve into the mainbodyComment
-
Try a different size power tube spacer.Comment
-
its like the x-valve is letting all the air go through and not restricting any of it... i have a ult kit on it also...
im also new to mags, what exactly is the power tube spacer?Comment
-
Take the powertube assembly apart and clean the o-rings. It is possible that a piece of dirt got onto one of the o-rings. Replace the parts once they are cleaned and lubricated. If the leak continues, remove the powertube shims and try it again. If it still leaks, use a carrier that is one size smaller. If all that fails, replace the defective carrier o-ring and go through the level 10 setup procedure.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment