Help! I have a "classic" Automag RT marker ... will E-Mag lowers work on this gun? Or is there an alignment issue?
Much to learn, have I ...
Much to learn, have I ...
-
A fanatic is one who can't change his mind and won't change the subject. -- Sir Winston Churchill
-
Yes they will work as far as i kno -
Hi
I think they should work. But you need to keep the Rail for the Classic because of the Banjo bolt....
Little_HoComment
-
Isn't the field the hole for the field strip screw too small if your trying to put a banjo bolt through it?
Comment
-
Theoreticaly,they will work....
However....
You will need to do a few things first.
#1 - the Classic RT has a single o-ring on/off. You will need to find someone that will drill it to accept the 2 o-ring configuration. Any AGD e-mag has 2 orings in the on/off top. One of which is the special "quad-oring" this help the on/off pin move easier. I think BradAGD still offers this serivice.
#2 - you will need to have the rear feild strip screw hole in the grip frame drilled out to fit the RT banjo bolt.
#3 - you will need to get the emag on/off pin. I forget the length, but its specific to the emag.
Technically, thats it. But Im not sure if its been done before.Comment
Comment