Looking for A peice

[Phalconavatar]

I'm looking for the metal lines that I have seen run on lots of the rt mags. Instead of a marco from the gas thru to the bolt, its actual metal tubing. I'm not talking about steel braided line either. I'm new to mags, so excuse me if I sound a little noobish on the subject.

**I'll try and find a picture later tonight, no time now got to get back to work **

[Maggot6]

You mean hardline? Go to Whitewolfairsmithing.com I *think* he does that, just send him your marker or very very specific measurements. If that fails, ask *chronobreak* on this site where he got his hardline. Good luck
And welcome to AO

[Phobos]

Don't people use break line from cars sometime?

[Phalconavatar]

thanks I will check that stuff out... didn't know if anyone actually carried something.

[Phalconavatar]

well whitewolf isn't carrying them anymore so if anyone else has any ideas... I'm gonna pm chronobreak, but is it with the * or with out???

[Jaan]

It's like the brake lines in a car. With the right tools it's easy to do. The tools arn't that expensive, you can usually get them cheap at someplace like Harbor Freight Tools. Just ask your friends, and thier Dads if any of them know how to do it. If you live around Massachusetts, the owner of my local paintball store could do it for you, just send me a PM. Any good shadetree mechanic can figure it out.

[sbpyro]

https://www.mcmaster.com

Look under steel tubing
They usually have the pressure rating and everything on it.
I'm planning to do the same thing looks like it will cost around $45 for the setup I want to run.
Also when you are bending the tubing you should have some filler in it otherwise it will just collapse.

[monkeyking]

You don't need filler, just a tubing bender.

But no one's asked the hard question: why do this at all? Why not use a flexible system when the benefits of flexibility are so much greater than the benefits of rigidity?

[RazorMonkey]

Form over function

[monkeyking]

Great monkeys think alike.

[Vex]

Looking for A peice

Aren't we all?

...Oh, wrong thread...