too agrivated to look for this...

[kcam911]

I have a Mag with the Lvl 10, X-valve and the ULT, and for the life of me i cant keep it working. Everytime it only works for a few days then it just stops. Heres how it is rite now, i have 3 shims in the lvl ten with the LARGEST o-ring carrier and i doesnt leak, also i have 7 shims in the ult, when it gases the trigger stifens but when you pull the trigger you get nothing. Like the pin is too long or something, dunno what to do. Help plz

[Maggot6]

Depends on how long you have owned the mag,. For about a case of paint it will break in slowly, and that is probably where your sitting at, So just keep ajusting it forthose few days, and soon, you will practically never need to again.,

[BigEvil]

Sounds like a ULT issue. Have you tried changing the amount of shims to see what happens?

[Little_Ho]

I agree with BigEvil.

Sounds like an ULT problem. remove your Shimes and start putting on in at a Time


Little_Ho

[athomas]

You could have no powertube o-ring at all and not have any leaks if there are too many ULT shims in place. When this happens, the on-off pin will never allow air into the front chamber because it never clears the on-off top o-ring. A

s suggested, I would suggest removing a few ULT shims and try that.

Also try to turn up the velocity or try a shorter/lighter bolt spring.

[kdrx1]

I set my bolt once and never had to again. I never had these breaking in things i hear so much about. And setting the bolt took me 15 minutes and was easy as pie.

[jaredborne]

I had that problem... I undid the velocity adjuster and put it back... works liek a charm now