whats faster x-valve with or without utl

[robertdimick]

with everything being the same, for example intelliframe, lvl10 bolt, and flatline 1200psi input.. what is faster? x valve with or without utl?

[Dayspring]

It depends on the setup of the ULT.

But I'm leaning to without...

[chairman_mao]

Sort of depends on the user too. Some really like ULT and have a better feel with it others can't find their rythm with ULT.

[stop whining buy a mag]

Scientifically the X-Valve without the ULT is going to be faster. With 1200 PSI going into the gun you may get the X-Valve to be a little bit more reactive with only the stock on/off. The ULT basically slows down the recharge rate so it the stock on/off will be faster. If you can walk your ULT and it bounces then you may have an advantage over the stock on/off.

I guess this really depends on the gun and its reactivity.

[Carbon Blue]

definitely with 950-1000psi the stock on off is going to be faster due to severe reactivity. Id say its definitely depends on the person on what they feel more comfortable with .

[TDonovan]

I short stroked/chuffed my ULT too much. If I had it to do again, I'd have gotten it with the stock on/off, not the ULT.

[REDRT]

My classic RT is no where near the speed of the RTP with the ult installed. Again it would have factors like the imput psi, state of tune in the set-up, the user ect. I like the ult alot. So much I might just have my Classic RT valve milled for it.