Q-Loader/Warp body

[monkeyking]

I've got a Q-Loader mounted on my 68 right now, but it seems to me that the low profile aspect of the marker would be further enhanced (not to mention being able to see down the barrel) if the balls game in one side or the other, rather than via the power loader.

Does anyone have experience with a Q-loader (or, I suppose, a Warp) and a direct feed of one direction or another? What bodies are available commercially? Who can modify a body to lower it?

[zackzel]

if you by a warp ule body the feed goes directly in the side of the body, so you can sight right down it.

[monkeyking]

Oh, big duh. Thanks!

[luke]

There is a much cheaper route.

See post #15 >>

http://www.automags.org/forums/showthread.php?t=155104

[monkeyking]

There is a much cheaper route.

See post #15 >>
http://www.automags.org/forums/showthread.php?t=155104

Oh, yeah, I saw that and didn't quite grok.

Did you fabricate a new feed tube and solder it to a body, or did you fabricate the entire body?

And a follow-up: can one use a pipe cutter on the feed tube on a steel mag body? It's just so damned long, you know?

[luke]

Did you fabricate a new feed tube

Yes.

and solder it to a body,

No.
They are T.I.G. welded.

or did you fabricate the entire body?

No.

Basicly you send me the body and I put a new feed tube on it. You can still use all the same barrels you have, nothing changes but the tube configuration.