Well, I sorta commited a sin...I decided to buy this cocker http://www.automags.org/forums/showt...threadid=22476 but in no way will this replace or become my Intelli-retro mag. As the post states the cocker is missing its 3 way set screw. Does this mean it will have to be timed? Most likely, but I was wondering if anyone would go through the proper timing procedure to get it going. Thanks in advance.
Proper cocker timing
Collapse
X
-
as long as it has one 3-way set screw it will stay in place
cocker timing takes a while but it is pretty basic, its just adjusting rods and such until it shoots perfectly(its easier if its sitting right in front of you), search for websites(i think ravi's talks about it) on how to do this for more detail
Note:little hole on top of body is important
I find cockers are as basic as mags once you understand them-Minimag Body HR
-Retro Valve
-Z grip with extender
-12V X-Boarded Revvy
-6 barrels including:10 Inch DYE SS, 8 inch Steel Wind, 8 inch stock minimag barrel, 12 inch BOA barrel, 12 inch Lapco Autospirit, 16 inch SPAA
-68/3000 Flatline
Comment
-
hmm.Could u go into a little more detail like how to adjust the actuator rod ect?"I may be half human, but Im all Woman"
Retro PF Mag
Lvl 10
Intelliframe
DYE 12" aluminum'
KAPP foregrip
68/3k Flatline
KAPP DZ2
1987 VW Scirocco 16v
GOOD TRADERS: Alf, Snakestang
BAD: iNeedaN2tank!
Comment
-
If you want to know and understand Cockers, go to this webpage and read. This site is better than Ravi's in my opinion.

"When you get married, you learn really quick that there's a good time, and a not so good time, to start playin' snap-shooting-from-behind-the-couch moves with a brand new $1,000 paintball gun." -Jack & Coke
Comment
Comment