x-valve vs e-valve
Any significance between the two? Would the e-valve be useable in a stock minimag? Thanks.
-
-
The Xvalve is an all aluminum RT valve. The Evalve (I figure Emag valve) is the stainless steel version. Same valve.
Yes, it's usable on a minimag but you'd need the proper length on/off pin. (.750")
That's the only difference- the Xvalve upgrades come with a .750" pin. The Emag Valve won't.
Secondly, the Xvalve can accept the ULT. The Emag valve might. (see if it has 2 orings in the on/off hole in the valve.) -
Thanks for the quick reply. How hard is it to get a .750 pin and install it? I'm not too worried about the ULT for now. I have a Boo-Yaah frame on their currently and was under the impression the ULT wouldn't help it.Originally posted by DayspringComment
-
Really easy. Go to www.airgun.com, click parts, then go the emag parts section. Order the pin for the Emag (it will say the pin size in description. Will set u back $8 plus $6 for shipping. Had to do the same thing for my mag......
Also, ULT's arent recommended for Emags.
Originally posted by afortunaComment
-
The ULT WILL help with the booh-yahh frame. It will make your battery last longer since the noid won't have to do as much work.Comment
-
Correct.Comment
-
ult
most of the emag valves take the ult.
as long as it has the quad oring with the white oring on the out side of the black oring ..
from what i hear some of the older emag valves wont take the ult ..Comment
-
Correct. Any Emag valve (has to be laser engraved Emag) before serial # 1000 will not use a double oring on/off.Comment
Comment