LVL7 bolt prob

[AGDlover]

OK guys I'm trying to install my lvl7 bolt kit and well the bolt wont set where it should be its sitting about 2.5-3mm off the bumper. So whats wrong is the PT just too long or is this fine?
Also this is on an Xvalve

[FlawleZ]

I'm assuming you mean LV10 bolt kit, right?

[AGDlover]

nope lvl7 i took out my lvl10

[MonsterMag]

He is removing the Level 10 and installing Level 7 and ace :)

[AGDlover]

bingo

[warbeak2099]

Wow, that saounds wierd. It does sound like the pt is too long. But I do know you can put a lvl 7 on an x-valve. Ask GA Devil. He puts the kits on his devilmags with eyes.

[AGDlover]

ok guys heres a pic just so you can see

[AnthonyDStone]

Power Tube

Whats in the power tube??There should only be a spacer and an o-ring.I believe....Haven't messed w/ lvl 7 in a while.

Tony

[AGDlover]

all the internals are lvl7

[AGDlover]

well guys i called AGD and talked to Roman and he said it COULD be the tip because thats where it seems to be hitting and it really wouldnt matter what spacer I had in there curently because of the bolt hitting the tip so if anyone wants to throw a new lvl7 tip my way that'd be awsome!

[Scott Hudnall]

stupid question, but you're sure you've removed the L10 carrier? What size power tube spacer are you using?

[zackzel]

Thats strange, that should definatly sit right down in there, I don't think it would be the tip though there has got to be something catching it in your powertube. By the way good idea, I did the same thing to my X-mag a few weeks back and it works great.

[AGDlover]

nothing in the stem of the bolt allready discused that with roman

I'm wateing for my .220 spacer to come in from tunaman that clasicmagger told me to use with a xvalve

[AGDlover]

ok guys found the problem it seems I put in the lvl10 backing washer oring since i dont have the lvl7 oring and it was preventing it from going down all the way since the center of the washer is smaller than the bolt stem.