Milling help

[gimp]

I have a question about some milling on my E-Mag. My intention is to mill the rail that the battery slides into on the front of the trigger guard, so that I can take the battery off without removing my drop forward (It's a kapp DZ2). I did some rough measurements. The battery slides down about an inch before it hits the drop forward. I think I just need to mill off about half an inch on the little rail to be able to accomplish this. I guess my main question is; Will the battery pack be real secure (will it wiggle or anything)? I'm just curious about how much is to much to take off.

Thanks,

Eric

[Load SM5]

The SFL's have the battery rail milled away pretty much like you discribed. There's only about 7/8's of an inch of rail on the bottom so I can remove my battery while keeping the drop on, something I love. The battery does wiggle just a bit but not very bad at all. Something that might help a bit is to leave the 7/8 at the bottom and leave about the same amount at the top. Just mill away the rail in between. The battery should slide down past the top 7/8's and still be nice and secure with the screw in. Just take off as much as you need to get the battery off...you can always take more off.