Retro Valve Tuning

[gibby]

Okay, I'm a bit excited here as I just got mine today...yay! However, I've been reading some of the previous posts and was wondering as to what extent does the "tuning" of the RT Valve involves. I currently have a fixed air Pure Energy Tank, 48cu/3000 psi.

Also, I noticed that my valve came with three extra spacers that are of different sizes. Where do those spacers go and what exactly do they do in terms of tweaking. Much thanks.

[Xzion]

The only real fine tuning you should need is the spacers you recieved with the valve, you may or may not need to use em, if you unscrew the power tube tip, you should find a spacer beneath that, you replace them there, if your getting bolt stick, install a longer spacer, if your getting barrel leak, install a smaller one, another thing you might want to look into is the length of the on/off pin, which you can order various lengths from AGD, the frequency this needs to be alterd is rather slim mind you. If worse comes to worst, you could send it all into AGD and have them fine tune it to your 'mag.

[gibby]

Thanks a lot for the response!