Input pressure of lvl 7 valve

[mattress]

What is it??

[argnot]

do you mean
1. What is input pressure
2. What is my minimum input required
3. What is the input for the tank I have
Welcome to automags. The more info you provide the easier it is for us to answer your question.

[Maggot6]

The level 7 is not a valve, it is a bolt. YOu could put a level 7 on any (well, probably even the sydarm..) valve AGD makes. YOu should restate your question as "What should the input pressure for a ______ valve be?" ALthough,I assume you mean a classic valve..

But your in luck, all AGD valve takes a high pressure input, so roughly 750-800 Psi.. :)

[Dayspring]

TECHNICALLY, the minimum input pressure is 600psi. That's because as a rule of thumb, you want a 200psi difference from input of a regulator to output. (The operating pressure of a mag is ~450psi.)

[mattress]

Ok, so about the same as the lvl 10 then. Sucks, reason I asked is due to my poor shot count, since once my tank gets to around 900psi left I get drop off, which is understandable due to the required input pressure. Was hoping the lvl 7 would have a lower input so I could make better use of the 1000 or so psi left in the tank instead of having to re-fill after about 4 pods worth of paint. Thanks for the info, I've been on the board for a while, but thanks for the welcome

[player4]

You really need to adjust your level 10 if you are having drop of at 900 psi. Either that, or you have a bad guage. My level 10 is brand new, and I get drop off around 600 psi. Although, level 7 will make your marker more effecient, but I am not sure how much more effecient.

[mattress]

Bought the RT ULE Custom new and it's worked flawlessly, so I never have messed with the valve other than putting a drop of oil in the air line occasionally. I have a dynaflow reg, and the input pressure is around 800psi, haven't read any reviews or tests on the dynaflow, so maybe it's my reg, maybe it's my guage, thanks for the tips, I'll check it out.