My classic mag is leaking out the back of the valve everytime i screw in my tank. How do i fix it? I need it for a backup in a three man tourney tomorrow
-
OHIO CPPA MEMBER -
Turn velocity down, and as always, lube it up
See if that works.
-
What's happening is that your pressure is too high, causing the safety to leak out the rear of the valve. using a shorter/lighter spring will allow you to get your velocity up without such high pressure.Comment
-
What speed are you shooting at? Try reducing your velocity as stated above. Check your reg piston o-ring. If it still vents below 300fps, get a new reg piston.Comment
-
Yes, try turning down the velocity. Clean the back of the valve. Inspect the regulator piston assembly o-ring. If you have had the valve apart at all lately, chances are, the regulator seat o-ring is bad. Replace it. If these all fail, then you may need a new regulator piston assy.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment