Emag Noid Problem

[Phantom_Mag]

Okay so yesterday as of 9 at night my emag worked great, i have exactly 8, 531 shots on it since i last charged the battery fully. I went to a turny and started play at 9 in the mourning, emode wont work, when the mags is not gassed i can here the noid clicking when the tirgger is pulled, but when i pull the trigger when it is gassed the sear just pulls back and does not reset, the mag works perfectly fine in mech mode (THANK GOD). ANy suggestions or ideas, im not exactly sure whats wrong, and befor ei tear it apart i figure i just asked since i have never had this problem.
THANKS IN ADVANCE,
PHANTOM

[Maggot6]

Are you sure that your HES magnet is in the right place? (well more, not to far out...)

[Phantom_Mag]

Edit i was wrong with the problem, the noid works but when its aired up it doesnt have enought strength it seems to pull the sear to fire the gun, if i take the valve out and put my finger on the sear portion that hits the on off pin it will fire rapidly, just not under air pressure.

[Phantom_Mag]

FIXED Half dead battery and a wrong on off pin.

[BigEvil]

OK, this is more common than you may think...

Take the on/off assembly out. Change ALL of the orings...ESPECIALLY the black quad oring, and the oring INSIDE the on/off. Then lube it up good, and put it all back together. Run some more oil through the valve, and shoot it a bunch to break everything in nice.

Once you eliminate oring swelling then you can start to look at things like battery power and noid problems.


This has happened to me a bunch during the hot humid weather. Once I changed the orings it has been fine.