autoresponse frame

[bleachit]

does anybody know what type of spring the inside of the frame needs and where I can get it?

the frame doesnt like to shoot the second round.. just the first. if I adjust the input pressure higher, the first ball fires, then on the return it sticks. If I lower the pressure, both balls fire but they dont go very far. So this leads me to believe the spring in the frame is too small.

any help, please?

[bleachit]

anyone out there?

[BigEvil]

Send the guys at AGD an email. I know AGDJON had an AR on hit RT and it ripped

[Muzikman]

It's not the spring. Make sure the sear is not binding.

[bleachit]

I dont think there is anything for it to bind on.. the screws are flush, or close to it. there is some side to side play in the sear, but there is not much I can do about that.

thanks for the help

[pointman]

autoresponse frame

Make sure the two screws that hold the frame to the rail are not to tight,just snug.Clean and inspect the on off and oil real good.

[bleachit]

its not the on off... I put on my bench 2x and it shoots beautifully, but thanks, if I get around to putting the autoresponse on, I will make sure do to that

[Cow hunter]

ive talked to many AGD techs an all of them told me NEVER adjust the input pressure....... should b at 800........... u may need a different size carrier/more or less shims mine just had the same problem :)

[bleachit]

Im running my mag on co2, I was talking about the palmers reg that I was adjusting...sorry for the confusion.