Few Problems with Emag Valve

[lamingo]

First im running a 47 cu Compressed air tank and there are velocity spikes of around 30 FPS or so
Second Every once in a while two balls will shoot from the gun i dont know of this is due to a bad detent or what im running a level 10 seems to hit the first ball and it doesnt leave the barrel , lvl 10 resets or somehting i dont know, then next ball into the chamber then they both come out. i Think those are all the problems for now if i think of anymore i will let you know

Thanks

[athomas]

Velocity spikes are generally caused by inconsistent paintballs. More than one paintball in the barrel is usually caused by a bad detent. The level 10 kicking in would generally prevent the bolt from pushing the ball far enough to allow another into the breach. If the bolt did push the ball far enough, then the second stage would have kicked in and the bolt would have finished its firing cycle. However, there are exceptions to everything. If the detent isn't the problem, check your level 10 setup.

[darrickws]

Well...

It could also be too tight a carrier on the level 10. So 1st shot bolt sticks, then loosens a bit.

[athomas]

Usually a carrier that is too tight would prevent the bolt from going forward far enough to allow a second ball into the breach. The bolt wouldn't have enough power to push the ball past the detent. If the bolt did travel more than 1/4", then the more forceful 2nd stage kicks in and the bolt would finish its cycle.

[lamingo]

Thanks for the input i'll give that a try havnt gotten to it yet