Will the RTP rail work with a classic mag? I just need to know. Thanks.
Cody
Cody
-
-
depends upon the body you are using. It will certainly work with the valve...no problems there....but where the front grip frame screws into the body.....that is different on the RTP/Emag bodies vs the Automag/Minimag bodies.
RTP/Emag rail has a round "slot" for this to sit into, while the AM/MM rail has an oblong "slot".
The RTP/Emag body "may" work with the AM/MM rail, but certainly the AM/MM body won't work with the RTP/Emag rail.
You'll see the difference if you take a look at the AGD home page, look at the body styles. -
i recently put a RTP rail on my classic. i dremmeled the rectangular part on my minimag body to be round. its easy, but takes a while. i used a few cut-off disks to do it. and the body didn't want to sit flush, and i narrowed down the source to be the twistlock assembly. i filed around the hole in the body designed for it, and it poped into the rail with no problem.
i went to shoot it. shot fine.
went to take the valve out, not fine.
the rear of the sear couldn't go up high enough to push the on/off pin all the way in, so the pin was snagged on the body. i dremmeled the back of the hole in the body designed for that to widen it up a tad bit. and now everything is perfect and shoots great.
maybe that will help you.upgrade fund: $145
Comment
Comment