New Dallara With problems

[electriceel125]

I traded for a nice dallara mag but im having trouble with it.


dallarabody
x vavle
intelli
LvL10
ULT and stock on off

Its been a while since ive had a mag so im a little rusty, so please bare with me.


I air it up with my HP legionair tank. It starts to leak like CRAZY out of the barrel. So i pull it apart and try to find out what is wrong. I take out the stock on/off and a hard white oring falls out of the bottom. Its broken no less. I put in the ULT while oiling every really well. I put it all back together and try again. Still leaks like mad from the barrel. Did i need that Little white broken oring to go the the ULT?


PLease help i dont have much air anymore and am trying to get it to work right before i run out.


Lee

[tae]

Yep.(i think) Im new to this as well but the first thougth I have is if its in there is should be. But from my understanding, the on/off wont work.

Someone smart correct me here.

[electriceel125]

It was in there with the stock on/off, but i dont think it needs to be in there with the ULT. Anyideas on what i can do to fix it would really help.

[tae]

i think it dose to make the seal. Otherwise air shoots through the on/off. what happens when you hold the trigger?

[TMAXXKING1]

nope

the ult doesnt use the oring that the stock on/off does

as for the leak down the barrel try the smallest carrier in the lvl 10 with 2 shims in the power tube

use the shortest spring ..

give that a shot

if you can only use the ult to tune it start with 3 shims in it before trying to tune the ult fix the leak down the barrel..

[TMAXXKING1]

tiny

there is a tiny oring in the bottom of the ult ..

you dont use the stock rt on/off orings with the ult . in the directions it tells you to remove them when installing a ult

[tae]

ah, I was just guessing. Thanks for the save.

[electriceel125]

Ill try that the shortest carrier and springs. Im trying to all this from memory with no directions, so any help offered is appreciated.


Lee

[Coralis]

The ult and level 10 both require tuning, many people find its easier to tune the level 10 first using the stock on/off and then tune the ult after you have the level 10 taken care off that way your not trying to tune one item and having the other give you unrelated problems .

[electriceel125]

I now have the stock on off working. (found a new o ring) Its not leaking anymore. I have the smallest carrier in and the longest spring. When i air it up the sear comes out but with no real pressure i can push it back and it wont fire.


On another note, i found out why it was leaking so bad. The guy who sent it to me left out the white o ring that goes in the carrier and a few other needed pieces.

[blamtro]

you need to find the largest carrier that will fit but not leak down the barrel when assembled.

[electriceel125]

carrier number with the one groove leaks but the one with none does.

[blamtro]

there should be an in between carrier with just a dot on it. Make sure the the piston has some oil on it so it slides nicely through the o-ring. If you still cant get it, start from the beginning with a fresh o-ring. Remember to always use the same o-ring and becareful as you switch it from carrier to carrier.