Ok, I am *almost* sure my newly acquired micro is a gen 3. The detent is the type with a rocker arm, and you must push the pin out to get the assembly out. My question is how stiff/long should the spring for this be?
The one that was in my gun is pretty much shot. I threw a Richochet Apache on the gun and had half my hopper drop out the front.
I've heard using too strong of a spring screws with the bolt movement.
Even better of a question, is there a vendor who stocks the correct size/tension spring for this?
BTW: Its freakin beautiful. Red/black anno, wood-grain grips, anno'd Armson barrel...mmmmm
!EDIT! Also, anyone know if the sear pin used for this is a standard type pin easily available?
The one that was in my gun is pretty much shot. I threw a Richochet Apache on the gun and had half my hopper drop out the front.
I've heard using too strong of a spring screws with the bolt movement.
Even better of a question, is there a vendor who stocks the correct size/tension spring for this?
BTW: Its freakin beautiful. Red/black anno, wood-grain grips, anno'd Armson barrel...mmmmm
!EDIT! Also, anyone know if the sear pin used for this is a standard type pin easily available?
Comment