How do I adjust the Xvalve trigger rod

[slateman]

I think its too long. Rob said it was anyway So I'm trying to figure out how to do it. Do I have to pop out the trigger? Is that what the metal pin between the "M" and the selector switch is for?

[GoblinGreen]

Im assuming cause you said it has the M/E switch its an Emag.

Remove you Frame from the rail, dont forget to remove the sear pin. open the grip on the side of the frame where the M switch is. you will see a sirclip on the solinoid plunger. remove the sirclip and the sear and plunger remove out the top of the frame.

Just make sure the length of the trigger rod is correct, you can find the right length if you do a search.

[slateman]

Thanks, but what is a sirclip?

If it matters, I'm using this diagram as a reference

EDIT - I got it. According to the diagram its called an Eclip