Morlock trouble

[11 Bravo]

I installed my morlock and wired the capacitor like so: pos battery wire to pos on capacitor then from capacitor to board. Then neg battery wire to neg on capacitor then from neg on capacitor to board.

I then set the firing modes and it fired great for a few shots & then quit firing. It would then only fire every few trigger pulls.

Any ideas.


this is in a Hyperframe.

[SpitFire1299]

Everyone said this to me when i had problems.. maybe i can help.

Check your dwell, make sure you have a new battery, make sure all wires are plugged in correctly.. and none are loose.



It may not help, but atleast i tried.

[11 Bravo]

Ok, everythings good now. I adjusted debounce and dwell and its firing good.