What rail to use for ULE WarpLeft Body?

[davidmoore714]

I recently picked up a ULE warp-left body straight from AGD. I was going to use the stock rail on my Classic mag, but I would have to modify it (cut a slot for the feed port and remove the twistlock pin). I would much rather buy a new one... but Im a little new at this so I dont know where to start shopping.

Long story short... Ive got a ULE warp-left body. What are my options for rails?

[Gunitwanksta]

the mag smith

[Beemer]

Hey

What are my options for rails?

Lets start a warp body railalution Youre options are any rail ya want, but you will still have to mod it with a notch. No one makes a rail with the notch for a warp body

Best bet is member [RogueFactor, or TheMagSmith.com] same guy, or maybe TunaMan. Check the dealers Forum.

I need to find out to. I want a Dallara notched for a ule warp body

Peace Out

___________

[davidmoore714]

I know this is kindof an old post... but its my old post so I wanted to update. I was planning to wait until after Christmas and actually BUY a rail for my Warp Left body (or have someone make me one) but I got impatient. Took the dremmel to my classic rail last night. What I ended up with was a nasty-looking notch on the left side of my class rail... but it works! I'll play with this one until I get tired of the wise cracks and jokes between games. Then I'll spring for something professionally done. I'll get pics up eventually.

[Arstron]

When I first got my warp setup with a ule warp body, I used a bench grinder and very steady hands to mill mine, it turned out fairly clean and even. I dont suggest this though, becuse the risk of screwing up is much greater then with a dremal.

[BigEvil]

Talk to LUKE. He can cut the notch for you.