well yesterday i got new orings for my mag. recently my on/off blew otu cuz there was pressure in it when i took the valve out. so i got the valve diagram from airgun.com an then i looked at the bottom of my valve and i figured otu where everythign goes. i lube it all up real good. aired it up and it leaks out of my on/off, but it still fires kind of. i need some help to make this work. thanks
-
my ao feedback http://www.automags.org/forums/showthread.php?t=167490 -
maybe the on/off pin is upside down. the solid end of it goes in and the notched end sticks out of the on/off. -
mine blew up too. took me an hour to find all of the parts and I nearly lost an eye when it shot out. Kinda funny and scary at the same time
Comment
-
the on/off pim is in right , i dont get it my ao feedback http://www.automags.org/forums/showthread.php?t=167490Comment
-
If it leaks out the on-off, then it could only be one of two orings, the small inside oring around the middle of the on-off pin (between the top and bottom sections) or the outer large oring around the base of the bottom section.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment