Warp 90 getting balls stuck.

[SGTKennedy]

i searched for this and couldnt find a fix, so im posting. i didnt search very hard if theres a thread about a fix please link me to it.
I have a HL rt and my warp is set up with the 90* right off the warp then the hose up to the bottom of the powerfeed.
The warp will feed forever if it keeps on spinning, but when it stops the balls get stuck. I stick my finger in the 90* hole to push the ball and it feeds just fine until another gets stuck. This happens 2-3 times per hopper full if i just keep the warp spinning, not attached to the gun, and when its on the gun it happens more often.
Does anyone have a fix? id rather not go to the top of my pf unless i have to.

Edit: i checked out the Proper warp adapter ball stack, and fiddled with the height, and it still didnt feed right, after feeding about 200 rnds through it to make sure.

[BlueMagRT]

it sounds to me like you have an old 90* elbow. you can either wait for agd to get the new ones in. or you can file down the side the p/f plug goes into. what i found on my elbow was that the p/f plug did not go in far enough. it should stick out into the opening by a hair.

[SGTKennedy]

mmmmm that makes sense. i'll call agd tomorrow about getting a new one cuz this one is cracked anyway, then ill take it to the shop and buzz it down.

[BlackVCG]

Did you check out these two threads?

http://www.automags.org/forums/showthread.php?s=&threadid=12911

http://www.automags.org/forums/showthread.php?s=&threadid=12140

[SGTKennedy]

yes, and ive tried fiddling with the adapter, and put plenty of balls through it to make sure it wasnt a fluke, and they still stick, so i am going to lower it to see if thats my problem, because i dont have the lip mentioned. but that means i have to cut it. and i was timid to do that before the new ones were announced.

[plaser]

I'm having the same problem with mine,balls will suddenly
stop feeding after a string of shots.I thought I had the newer one,however the balls are getting stuck right at the
powerfeed plug,I have also played with the ball stack(perfect)and I have the newer PF plug.How are we doing on the new 90 degree adapters? Any input would be helpful

[SGTKennedy]

what i did is took out the parabolic pf plug from the warp 90* and threw it into my toolbox and put the one from my PF in there. still a parabolic pf plug, but it must be a bit longer. cuz now it doesnt seem to do it as much.

[plaser]

Thx antwanRT,I'll try it and see how it goes.I'm
trying to mod a 90 degree pvc elbow to use instead,since
guys like you and me don't need the PF plug on the adapter.
Thx again.