EMag Fireblade installation.

[installer020]

I have an EMag and am wanting a new trigger. I like the looks of the Fireblade but have heard that they can have some problems with mech mode. Is this with all EMag's or just certain ones? What needs to be done to solve the problem? I understand that the LT3 and the Tunablade don't have these issues, is this true? Any info would be much appreciated.

Thanks,
Matt

[White_Noise]

only the first run fireblades had any problems with mech. the new ones have cleared this problem up.

installationg is easy, tap out pin, pull trigger out, put new one in, put pin back, adjust to your liking

[athomas]

I have an EMag and am wanting a new trigger. I like the looks of the Fireblade but have heard that they can have some problems with mech mode. Is this with all EMag's or just certain ones? What needs to be done to solve the problem? I understand that the LT3 and the Tunablade don't have these issues, is this true? Any info would be much appreciated.

Thanks,
Matt

I had a first run fireblade. It worked fine. It required an adjustment of the trigger rod to properly work in mechanical mode. I drilled a dimple in the back to allow better mechancial adjustment as well. The new ones have the indentation already drilled in the back. They are great working triggers.

[installer020]

Thanks.

Thanks for the inforation, once again AO has proven to be the ultimate source of informtion and knowlege!!