ULE Feedneck

[Jasonl619]

I just got a ULE Body for my mag and when I put the hopper in it's not very snug and comes out pretty easy. Not really in the mood to buy a feedneck right now. Anybody have any quick fix tips? Also, does anybody have a link to a good store to buy a clamping feedneck when I decide to upgrade?

[Cow hunter]

Quick fix =Duct tape

[fshrmn76]

Before I got a clamping feedneck I used to use a piece of an old broken tank oring. I just held the oring so it one of the ends was barely in the feedneck and pushed the hopper in. the hopper and oring slide in tightly and doesn't move.

[Lord_Whoopass]

Quick fix = electrical tape too... you will get a tighter fit from tape but normally isnt the best...

And when you do purchase a clamping feedneck, I would suggest the Sub-Zero... I like it alot more than the CCM ones... Height wise its between a CCM no rise and no-pro rise and its got alot better of a hold on your hopper than either...

[Coralis]

cp products make or did make a sleeve that went inside the neck of the hopper, it was tapered so that the farther it went in the more it expanded the hopper neck thus making a tight fit and they were cheap like 8 bucks or so.

[DaveA]

I'll go looking but in case its not self evident, what thread IS the feedneck. I seem to recall it being angel threading, but my mind is a sieve.
Thanks
D

[Tunaman]

Dye makes the spacer that goes in your hopper neck. They work great. I think I have a couple around here still. Email me.

[angelpena]

Will any Angel threaded feed neck work? what are the modifications needed to make it work? None of the vendors that sell them for mags seem to have a silver one to match my ULE body.

[Jasonl619]

automag ule feednecks and detents are angel threaded so anyone will work. The only color I've seen so far is black. It's hard to find the colored ones I guess.