shoot down

[alexpaintballer]

i am having exseevive shoot down with my automag with a classic valve with lvl 7

[Ace12GA]

CO2 or HPA? Cold weather? Vertical adapter, or bottom line? Remote coil or not? I get massive shoot down on my classic when its cooler than 20^C, on CO2 with a direct bottom line setup. When I use my remote coil and an expansion chamber, its a little better in cooler weather.

[alexpaintballer]

CO2 or HPA? Cold weather? Vertical adapter, or bottom line? Remote coil or not? I get massive shoot down on my classic when its cooler than 20^C, on CO2 with a direct bottom line setup. When I use my remote coil and an expansion chamber, its a little better in cooler weather.

hpa with vertical adapter and gas thru

[peewee]

What kind of hpa tank, some have a crappy recharge rate. Make sure its not a LP tank. Alao check your hoses for foreign materials, something could be clogged up.

[alexpaintballer]

it is a pmi 68/45

[JaredC]

I just took my mini out of hiding. It has been tucked away for like 5 years running gas thru and hpa level 7. I am getting run down also lately. The trigger rod will stay firmly pressed agains the trigger, but not getting any shots unless i take off the tank and put it back on. I oiled the hell out of everthing and am still having these problems. Please help.

[lifeguard_12_86]

your trigger rod shouldnt be pressed against the trigger you should have at about 1/16" of trigger slack when the rod is fully extended and the trigger all the way forward, also try turning the velocity up, it miht help , but im not sure

[athomas]

If you are experiencing shootdown with a level 7, try changing the bolt spring.

Also, if the trigger rod is touching the back of the trigger while at rest, then the rigger rod is too long and should be adjusted so there is a bit of slack (just enough so the rod doesn't touch the back of the trigger).

[scrumpy]

i am having exseevive shoot down with my automag with a classic valve with lvl 7

Inspect your regulator seat for damage and make sure it is in the correct way. If damaged, replace it. If not, replace it anyway and see if it helps.