Warpfeed Question

[SBS_Piper]

I have a warpfeed on a Automag 68 with a powerfeed. When I set up the warp as per the instructions ie: with the tube attached to the bottom of the powerfeed, the balls always fail to feed properly and I end up firing lots of air. If I connect the tube to the top of the powerfeed all seems ok.

Does anyone know of any reason why I can't leave it connected to the top, or any ideas on why it jams on the other end. The tube does have to wrap all the way round my foregrip...is this the problem??

Thanks in advance

[Shaft]

The extended barrel plug is a parabolic plug and if I remember right does have the adjustment screw on the top. You may need to adjust it if you are using large bore paint.

I used to have my warp feed wrapped around the foregrip and it worked fine.

An alternate method shown elsewhere on the forum, is to use the 90* adapter on the warp itself and then wrap the hose up into the bottom of the powerfeed. It looks nice like this.

[Dubstar112]

What side is your pf on? If its like mine, make sure you are using the extended pf plug- if thats not it, give some more details..

[SBS_Piper]

I have got the extended PF plug, but my powerfeed lies the other way, so the low side is on the right if you look from the back of the marker.

[Burb]

Yeah i have the same setup, i feed balls ok.
My tube goes around my foregrip and fits onto the bottom of the power feed.
I want it like that guy who has posted the picture!!!
But he is American, so reverse power feeds are more common.

Us Enlgish have to just manage, and wait YEARS for the bloody intelliframe / plastic nubbins and superbolts.