Help with mech frame?

[ShhBeQuiet9772]

ok... i just got an electronic frame installed on my mag and it doesnt quite work. when i hook up the nitrous to my gun, the air just leaks out of the bolt. it doesnt seem like the air is putting enough through to push the ult down far enough to trigger the solenoid. maybe im describing this wrong... not quite sure, but when i press the sear down with my finger or a hex wrench i can fire the gun with the solenoid going off. yet when the valve is on the gun it wont fire for some reason. if anyone has any clue what i am talking about please shed some light on this, i would be very appreciative.

could my on/off pin be too short?

[lifeguard_12_86]

what electric frame did you use, it could help us a little bit to find out what the problem is?\

[ShhBeQuiet9772]

it is a booyah frame... or a mock version of it

the person who sold it to me told me it was a booyah but someone at my local field said he didnt recognize it :Z

[lifeguard_12_86]

it could posibly be your on/off pin, i know they had an extra long one for the hyperframes, but that shouldnt be the problem with the air leaking out your barrel, that is either a problem with your level x bolt, if you have one or probably just an oring somewere,
what kind of bolt and valve are you running in your mag?

[ShhBeQuiet9772]

well we also tried fixing the problem by using another level 10 bolt and even another x-valve so i think its a problem with the on/off pin...

i will try posting an image of it later

[Coralis]

do you have a ult kit in this ?

[ShhBeQuiet9772]

yes i have a ult kit, but we also tried installing a stock on/off pin also